remote control RENAULT TWINGO RS 2009 2.G Electrical Equipment - Radio Workshop Manual
Page 22 of 42
86A-22
MR-413-X44-86A000$819_eng.mif
V1
RADIO
Fault finding chart86A
ALP 4The radio is switched on, but the display and control satellite do
not operate
NOTESFor radio versions with remote display.
The radio operates but the display does not
light up.
Check the functions of the display that are not
connected to the radio by switching on the “+
side lights feed” (screen backlighting and
exterior temperature).
Does the backlighting or exterior temperature
display work?
YES
Check the continuity and insulation of the wiring
between the radio and the display using a
multimeter (see Wiring Diagrams Technical
Note for New Twingo, code 261).
NODisconnect the aerial amplifier
(component 886).
Does the screen light up?
YES NO
C
BA
Page 25 of 42
86A-25
MR-413-X44-86A000$819_eng.mif
V1
RADIO
Fault finding chart86A
ALP 5 The satellite controls do not work
NOTESFor radio versions with remote display.
The radio operates but the radio control satellite
does not.
Does the remote display operate?
YES
Check that the satellite is correctly connected to
the display (see Wiring Diagrams Technical
Note for New Twingo, code 325).
Are the satellite controls connected correctly?
YES
Check the satellite resistance with a multimeter
(see Radio control satellite: Test).
Are the resistance values correct?
YES
NOSee ALP 4.
NOReconnect the radio control satellite and
check the system operates correctly.
NOReplace the satellite.
A
Page 27 of 42
86A-27
MR-413-X44-86A000$819_eng.mif
V1
RADIO
Fault finding chart86A
ALP 5 The satellite controls do not work
NOTESFor radio versions without remote display.
The radio operates but the radio control satellite
does not.
Check that the satellite is connected to the radio
(see Wiring Diagrams Technical Note for New
Twingo, code 325).
Are the satellite controls connected correctly?
YES
Measure the satellite resistance with a
multimeter (see Radio control satellite: Test).
Are the resistance values correct?
YES
Check the continuity and insulation of the
following connections:
–34AT, 34AR, 34AS, 34AQ, 34AU and 34AP
between the satellite and the radio.
Are the connections correct?
YES
Replace the radio.
NOReconnect the radio control satellite and
check the system operates correctly.
NOReplace the satellite.
NOIf there is a repair procedure (see Technical
Note 6015A, Repairing electrical wiring,
Wiring: Precautions for repair), repair the
wiring, otherwise replace it.